Section 6: Installing The Accessories - Montigo H38SVO-ST Installation & Maintenance Manual

Installing the Logs and Embers
Bottom Logs
The H38VO-ST is supplied with eight (8) fibre logs. The two small bottom
logs ("A" ) are mounted on the burner grate by placing them diagonally
onto the supplied Log stands. The long Front / Back logs ("B") are
placed against the grate as shown in Figure 11c. note: When placing
logs, arrange Logs "B" as not to cover Burner holes.
Top Logs
Next are the logs "C" which are placed diagonally, as shown in Figure
24d. The last Logs "D" are then mounted on top of logs "A" as shown
in Figure 11e.
waRnInG: If logs are not placed properly, excessive sooting will result.
Burner holes (front & back burner),
note hole pattern when placing logs
Air Inlets
Log Stand
Front of Fireplace
Figure 11a. (Empty firebox showing the Left & Right stands).
Log A
Figure 11b. (Place Logs' "A" on Left & Right stands).
Log B
Figure 11c. (Place Logs' "B" as shown, in front of Right-hand "A", and
behind Left-hand "B".
XG0817 - 030412
Installation
Log Stand
Burners
Log A
Log B

Section 6: Installing the accessories

Log C
Figure 11d. Log Installation. (Place Logs' "C" on-top of Logs "A".
Indentations on-top of Logs' "A"
Log D
Figure 11e. Completed log Installation.
Figure 11f. Place lava rock around wrought iron grate. Place embers
around burner holes. Do not cover burner holes with embers.
H*38VO-ST Outdoor Gas Fireplace
Log C
Log D
Page 11