Installing The Paper Guide - Epson ACTION T-1000 User Manual

Using Continuous-feed Paper
8. Pull the paper up until the top is above the pin feed holders. Fit the
holes along the left edge of the paper over the pins in the left holder,
as shown below, and close the pin feed cover.
9. Fit the right side of the paper into the right holder, moving the holder
as needed to match the width of the paper. Close the second pin feed
cover.
10. Make sure that the paper has no dips or wrinkles, then push the
locking lever back to lock the right holder in place.

Installing the paper guide

Install the paper guide, which is used here as a paper separator, as
described below. Note that the guide is installed in one of two different
positions depending on the type of paper you use. It lies flat when you
use continuous-feed paper, as described here, and sits upright for loading
single-sheet paper.
If the edge guides are not yet in place, install them by hooking the
1.
tab on the back of each guide over the top of the paper guide, as
shown in the illustration on the next page. Snap the bottom of each
guide into place.
1-14
Setting Up