Using Continuous-Feed Paper; Installing The Tractor Unit - Epson ACTION T-1000 User Manual

Using Continuous-feed Paper

The following section covers use of continuous-feed paper with your
tractor unit. If you plan to use single-sheet paper, skip to the
"Removing the tractor unit" section on page
The tractor unit for the printer allows you to use paper with pin feed
holes along the sides (continuous-feed paper). You can adjust the tractor
unit to accommodate widths of paper ranging from
including the pin feed holes.

Installing the tractor unit

You need to install the tractor unit each time you wish to load
continuous-feed paper after using single-sheet paper, which can be loaded
only when the tractor unit is removed.
Since your printer comes with the tractor unit installed, simply install the
paper rest by fitting it into the slots along the top edge of the back of the
printer and snapping it into place. (See the bottom illustration on the
following page.) Then see the instructions later in this chapter for loading
continuous-feed paper.
To install the tractor unit, follow these steps:
1. If the paper guide is installed, remove it by tipping it toward you and
pulling it out.
1-17.
to 10 inches,
4
Setting Up
1-9