Epson ACTION T-1000 User Manual page 20

4. Using the illustration below as a guide, pull the locking levers on
each side of the pin feed holders forward so you can move the pin
feed holders.
5. Place the left holder approximately 3/4 of an inch from the far left
position and then push the locking lever back to fasten that holder
into place. Leave the other holder unlocked.
6. Open the pin feed
7. Feed the paper into the paper slot. Push and maneuver the paper
through the slot until it comes up between the ribbon guide and the
platen (the black roller).
as shown below.
covers
Using Continuous-feed Paper
Setting Up 1-13