Exit Test Mode - First Alert FA162C User Manual

TESTING THE SYSTEM
Walk in front of any interior motion detectors (if used) and
listen for three beeps. The identification of the detector should
appear on the display when it is activated. The display will
clear when no motion is detected. Note that if wireless motion
detectors are used, there is a 3-minute delay between
activations. This is to conserve battery life.
To test all smoke detectors, follow the manufacturer's
instructions. The identification of each detector should appear
on the display when each is activated.
If a problem is experienced with any protection point (no
confirming sounds, no display), CALL FOR SERVICE
IMMEDIATELY.
When all protection points have been checked and are intact
(closed), there should be no zone identification numbers
displayed on the keypad
When testing is completed, exit the TEST mode by continuing
with step 5.
OFF
5. + 1

EXIT TEST MODE

Enter your security code and press the OFF key.
(Security Code)
If the test mode is inadvertently left active, it automatically
turns off after 4 hours.
– 30 –