Makita DCS 430 Owner's And Safety Manual page 15

3 :
li
1
I
2.
Cross cut
I -
ire special attention to
stress on the log
(see
fig. 33,34). The bucking
WARNING!
6. Onlyproperlytrained profession
in an area where the logs, limbs and roots are
tangled (i. e. a blowdown area, fig. 35). Work-
ing in blowdown areas is
e
ous.
NING!
7. Drag the logs into a clear area before cutting.
Pull out exposed and cleared
logs
first.
Maintenance and Repair
Never operate a chain saw that is damaged, improp-
erly adjusted
or not
completely or securely assembled.
Follow the maintenance and repair instructions in the
appropriate section of this manual.
WARNING !
Always stop the engine and make sure that the
chain
is
stopped
before commencing any mainte-
nance or repair work or cleaning the saw.
Do
not
attempt any maintenance or repair work not de-
scribed in this manual. Have such work performed
by your MAKITA service shop only.
Maintaining and storing the saw
Keep the chain, bar and sprocket clean and lubricated;
replace worn sprockets or chains.
Keep the chain sharp. You can spot a dull chain when
easy-to-cut wood becomes hard to cut and burn marks
appear on the wood.
Keep the chain at proper tension. Tighten all nuts,
bolts and screws except the carburetor adjustment
screws after each use.
Keep spark plug and wire connection tight and clean.
Store saws in a high or locked place, away from
children.