Important Notices; Cleaning Rc3200; How To Reset The Rc3200 - Marantz SR-12S1 User Manual

IMPORTANT NOTICES

Take care not to scratch the touch screen
Use your finger to tap the LCD touch screen or use plastic-tipped pens
intended for use with touch screens.
Never use an actual pen, pencil or other sharp object on the LCD
touch screen.
Protect RC3200 from extreme temperatures
Keep RC3200 away from heaters and other heat sources.
RC3200 is not waterproof
RC3200 should not be exposed to rain or moisture.
Do not store or use RC3200 in any location that is extremely damp or
wet.
When you have spilled water on RC3200, you have to take out the
batteries and let RC3200 dry for 48 hours before you place the
batteries back.
When you have spilled other liquids like coffee on the RC3200, you
can clean it with distilled water. Make sure no water gets into the
housing.
The touch screen of RC3200 contains a glass element
Do not drop RC3200 or subject it to any strong impact.
Replace batteries
In case of replacing batteries, the RC3200 has a backup function to
prevent some memory data such as the learned RC code, Macro from
being erased.
But, the memory of setup page (LCD, Lighting, Date, etc.) will be
cleared.
Please set again these contents, after you insert new batteries.

CLEANING RC3200

Use a soft, damp cloth to clean RC3200.
If the LCD touch screen of RC3200 is spoiled, clean it with a soft cloth
moistened with a diluted window-cleaning solution.
Do not use a corrosive detergent or an abrasive sponge.
Avoid the use of abundant water.

HOW TO RESET THE RC3200

Under normal circumstances, you will never have to reset the
RC3200.
However, on rare occasions, if the RC3200's touch screen freezes or
if you notice unusual behavior, you need to perform a reset to get the
RC3200 running again. All customized commands and devices are
retained.
1.
Slide the battery cover off the back of the RC3200.
You will see the Reset button in the battery compartment.
2.
Use an unfolded paperclip to carefully press the
Reset button.
The RC3200 restarts and an Introduction screen appears. The
RC3200 beeps twice to indicate it is ready for use.
22