Tuner Operation - Marantz SR5023 User Manual

TUNER OPERATION

LISTENING TO THE TUNER
Frequency scan step for AM is selectable.
Default setup is 9 kHz step, if your country's standard
is 10 kHz step, Press BAND button on the remote
controller more than 6 seconds. Scan step will
change.
Note:
Preset memory for the tuner will clear by changing
this setup.
AUTO TUNING
1. 2.
SP AUTO TUNED ST
LEEP DIRECT
(Using the unit)
1.
To select tuner and desired band (FM or AM),
press the BAND button on the front panel.
2. Press the TUNING/PRESET 3 or 4 buttons on
the front panel for more than 1 second to start
the auto tuning function.
3.
Automatic searching begins then stops when a
station is tuned in.
(Using the remote controller)
1.
To select tuner and desired band (FM or
AM), press the BAND button on the remote
controller.
2. Press the 3 or 4 for more than 1 second on the
remote controller.
3.
Automatic searching begins then stops when a
station is tuned in.
If tuning does not stop at the desired station, use to
the "Manual tuning" operation.
MANUAL TUNING
1. 2.
ISP AUTO TUNED ST
SLEEP DIRECT
(Using the unit)
1.
To select tuner and desired band (FM or AM),
press the BAND button on the front panel.
2. Press the TUNING/PRESET 3 or 4 buttons on
the front panel to select the desired station.
(Using the remote controller )
2.
1.
To select tuner and desired band (FM or
1.
AM), press the BAND button on the remote
controller.
2.
Press the 3 or 4 on the remote controller to
tune in the desired station.
DIRECT FREQUENCY CALL
1.
3.
2.
1.
2.
1.
To select tuner and desired band (FM or
AM), press the BAND button on the remote
controller.
2.
Press the F.DIRECT on the remote controller,
display will show "FREQ - - - -".
3.
Input your desired station's frequency with the
numeric buttons on the remote controller.
4.
The desired station will automatically be tuned.
ENGLISH
(FM) TUNING MODE (AUTO STEREO OR MONO)
AUTO TUNED ST
DIRECT
When in the auto stereo mode, AUTO indicator will
be illuminated on the display.
The "ST" indicator is illuminated when a stereo
broadcast is tuned in.
At open frequencies, the noise is muted and the
"TUNED" and "ST" indicators are not illuminated.
If the signal is weak, it may be diffi cult to tune into
the station in stereo. In such a case, press the
T-MODE button on the front panel or remote
controller.
"AUTO" indicator is not illuminated, if FM stereo
broadcasts are received in monaural and the "ST"
indicator is not illuminated.
To return to auto stereo mode, press the T-MODE
button or press T-MODE button on the remote
controller again. AUTO indicator is illuminated on the
display.
11 11