Marantz SA8003 User Manual page 28

ENGLISH
trOuBlesHOOtING
usB/ipod(sa8003)
Problem Cause
"OverCurrent" appears on The voltage able to be supplied from this
the display. unit via the USB has been exceeded.
An unsupported file system is being
"FAT Error" or "Cluster Err"
used. USB memory below 128 MB
appear on the display.
cannot be supported.
"No File" appears on the No file able to be played on this unit
display. exists.
"DRM Stream" appears on This is a file subject to digital rights
the display. management.
The amplifier and speakers are not
connected properly.
The amplifier power is not ON.
The sound of the USB being
The amplifier's function or selector
connected is not heard.
switch is not set to "CD" or "AUX" or
such (to whatever you have connected
this unit to).
The amplifier's volume control is set at
the minimum level.
3rd generation or earlier iPods are
unsupported.
The amplifier and speakers are not
connected correctly.
The amplifier power is not ON.
The sound of the iPod being
connected is not heard.
The amplifier's function or selector
switch is not set to "CD" or "AUX" or
such (to whatever you have connected
this unit to).
The amplifier's volume control is set at
the minimum level.
When connecting a high-capacity
USB device, it will take time to read
Reading of USB device
depending on its capacity. Several
takes time.
minutes may be required for reading
when using a high-capacity device.
24
Corrective action
The USB media is not supported.
Please use a USB device with an
operating current that is less than
500 mA.
Please use a USB device formatted
with a compatible file system (FAT32
or FAT) and that has at least 256 MB
of memory.
Check supported formats. ( Page
25, 26)
Cannot play on this unit because of
unsupported DRM. ( Page 25)
Connect the cables correctly.
( See the instruction manual for the
amplifier.)
Turn the amplifier power ON.
( See the instruction manual for the
amplifier.)
Switch the amplifier's function or
selector switch to "CD" or "AUX" or
such (to whatever you have connected
this unit to).
( See the instruction manual for the
amplifier.)
Adjust the amplifier volume.
( See the instruction manual for the
amplifier.)
Refer to "ABOUT iPod PLAYBACK".
( Page 26)
Connect the cables correctly.
( See the instruction manual for the
amplifier.)
Turn ON the power to the amplifier.
( See the instruction manual for the
amplifier.)
Switch the amplifier's function or
selector switch to "CD" or "AUX" or
such (to whatever you have connected
this unit to).
(See the instruction manual for the
amplifier.)
Adjust the amplifier volume.
(See the instruction manual for the
amplifier.)
Wait until reading is completed.