Advertisement
Switch action
To start the tool, simply pull the trigger.
Release the trigger to stop. For continuous
operation, pull the trigger and then push in
the lock lever. To stop the tool form the
locked position, pull the trigger fully, then
release
it.
Lock
lever
-
CAUTION:
Before plugging in the tool, always check to see that the switch trigger actuates properly
and returns t o the "OFF" position when released.
Operation
I
Hold the tool firmly. Turn the tool on and
then apply the wheel or disc to the work-
piece.
In general, keep the edge of the wheel or
disc at an angle of about 1 5 O to the work-
piece surface.
During the break-in period with a new wheel,
do not work the grinder in the B direction or
it will cut into the workpiece. Once the edge
of the wheel has been rounded off by use,
the wheel may be worked in both A and B
directions.
-
WARNING:
It should never be necessary to force the tool. The weight of the tool applies adequate
pressure. Forcing and excessive pressure could cause dangerous wheel breakage.
Continued use of a worn-out wheel may result in wheel explosion and serious personal
injury. Depressed center wheel should not be used after
it
has been worn down to
1 15 mm (4-1 12") in diameter. Use of the wheel after this point is unsafe and
it
should
be removed from service and rendered unusable by intentional destruction.
10
Advertisement
