Makita 2708 Instruction Manual page 23

To install the dado head set, proceed as follows:
1
Turn the tool off and unplug it before installing.
2
Remove the blade guard with the spreader.
3
Install the dado head
s e t
with the teeth pointing down a t the front of the table.
, 4
Use the chart below to select the proper cutters to obtain the various cutting widths.
I
I 1
1 I I I
CAUTION :
The outer flange or the dado outer flange must be used for each cut width.
The hex nut alone must not be used to secure the dado on to the spindle.
23