For Bevel Cuts; Stopper Adjustment; Rip Fence Adjustment - Makita 2708 Instruction Manual

FOR BEVEL CUTS
Raise the lock lever for bevel cuts to
release it, then swing the blade with the
elevating knob until it reaches the desired
angle from zero to 45 degrees. The bevel is
indicated by the arrow pointer. After the
desired angle setting i s reached, then lock
the lock lever by pressing down firmly t o
secure in place.
WARNING: The lock lever must be se-
cured very firmly or opera-
tion can be very dangerous.
STOPPER ADJUSTMENT
Loosen the stopper hex socket head bolt
and align the arrow pointer to zero and 45
degrees. Then slide the stopper and secure
the stopper in place carefully with the hex
socket head bolt.
RIP FENCE ADJUSTMENT
Adjust the rip fence whenever it moves
only with difficulty, sticks, or i s too loose.
Leave the ruler-attaching hex bolt and
underplate hex bolt in the semi-secured
condition. Then install the rip fence on
table and secure lock knob when the rip
fence is parallel with the blade. Now secure
the ruler-attaching hex bolt carefully.
9