Makita 2708 Instruction Manual page 13

Auxiliary
Wood
Facing (Miter Gauge)
To prevent
a
long board from wobbling, fit
the miter gauge with an auxiliary fence
board. Fasten with boltdnuts after drilling
holes, but fasteners must not protrude
from the face board,
Featherboard
The diagram shown illustrates dimensions
for making a typical featherboard. It should
be made from a straight piece of wood
thats free of knots or cracks.
24
- Kerf should be
7
about
114"
apart
Miter Gauge
Use the miter gauge for the 4 types of cutting shown below.
I
I
CROSS C U T T I N G M I T E R I N G B E V E L C U T T I N G C O M P O U N D M I T E R I N G ( A N G L E S )
CAUT IONS
1. Remove the rip fence from the table.
2. Secure the knob on miter gauge carefully.
3. Avoid creep of workpiece and gauge by firm workholding arrangement, especially
4. When cutting long or large workpieces, always use a work support in side.
when cutting
a t
an angle.
13