Function Settings - Kenwood KDC-4054UR Instruction Manual

Function settings

1 Press the volume knob to enter [FUNCTION] mode.
2 Turn the volume knob to select [AUDIO CONTROL] / [AUDIO CTRL] or [SETTINGS], then
press to enter.
3 Turn the volume knob to make a selection, then press to confirm.
See table below for selection.
Repeat step 3 until the desired item is selected/activated.
Press to return to the previous item.
4 Hold to finish the procedure.
[AUDIO CONTROL] / [AUDIO CTRL] : While listening to any source except in STANDBY state...
Item
SUB-W LEVEL Except for
–15 — +15 (Preset: 0): Adjusts the subwoofer output level.
BASS LEVEL –8 — +8 (Preset: 0): Source tone memory: Adjusts the level to memorize in each source. (Before
making an adjustment, select the source you want to adjust.)
MID LEVEL
TRE LEVEL
EQ PRO
BASS ADJUST BASS CTR FRQ/ BASS C FRQ
BASS LEVEL
BASS Q FACTOR/ BASS Q FCTR 1.00 */ 1.25/ 1.50/ 2.00: Adjusts the quality factor.
BASS EXTEND
MID ADJUST MID CTR FRQ/ MID C FRQ
MID LEVEL
MID Q FACTOR/ MID Q FCTR
TRE ADJUST TRE CTR FRQ/ TRE C FRQ
TRE LEVEL
PRESET EQ NATURAL */ USER/ ROCK/ POPS/ EASY/ TOP40/ JAZZ/ POWERFUL: Selects a preset sound mode
suitable to the music genre. (Selects [USER] to use the customized bass, middle, and treble settings.)
BASS BOOST B.BOOST LV1/ B.BOOST LV2/ B.BOOST LV3: Selects your preferred bass boost level. ;
B.BOOST OFF *: Cancels.
LOUDNESS LOUDNESS LV1 */ LOUD LV1 */ LOUDNESS LV2/ LOUD LV2: Selects your preferred low and high
frequencies boost to produce a well-balanced sound at a low volume level. ;
LOUDNESS OFF/ LOUD OFF: Cancels.
BALANCE L15 — R15 (Preset: 0): Adjusts the left and right speaker output balance.
FADER R15 — F15 (Preset: 0): Adjusts the rear and front speaker output balance.
SUBWOOFER SET/ Except for
SUB-W SET ON *: Turns on the subwoofer output. ; OFF: Cancels.
Selectable setting (Preset: *)
:
60/ 80/ 100 */ 200: Selects the center frequency.
–8 — +8 (Preset: 0): Adjusts the level.
ON: Turns on the extended bass. ; OFF *: Cancels.
0.5K/ 1.0K */ 1.5K/ 2.5K: Selects the center frequency.
–8 — +8 (Preset: 0): Adjusts the level.
0.75/ 1.00 */ 1.25: Adjusts the quality factor.
10.0K/ 12.5K */ 15.0K/ 17.5K: Selects the center frequency.
–8 — +8 (Preset: 0): Adjusts the level.
:
Continued...
15