Advertisement
ELECtRICAL oUtLEt
Suggested electrical
outlet location*
Figure 7
The electrical requirements are a 120 volt 60 Hz, AC only,
15 amp. or more protected electrical supply. It is recommended
that a separate circuit serving only this appliance be provided.
The drawer is equipped with a 3-prong grounding plug. It must
be plugged into a wall receptacle that is properly installed and
grounded. Should you only have a 2-prong outlet, have a qualified
electrician install a correct wall receptacle.
Note: If you have any questions about the grounding or electrical
instructions, consult a qualified electrician or service person.
* Can also be installed using an electrical outlet in an adjacent cabinet
within the area where the provided electrical cord can reach.
Always check electrical codes for requirements.
GRoUNdING INStRUCtIoNS
This appliance must be grounded. The Microwave Drawer is
equipped with a cord having a grounding wire with a grounding
plug. It must be plugged into a wall receptacle that is properly
installed and grounded in accordance with the National
Electrical Code and local codes
and ordinances. In the event of
an electrical short circuit,
grounding reduces risk of
electric shock by providing an
escape wire for the electric
current.
– Improper use
of the grounding plug can result
in a risk of electric shock. Do
not use an extension cord. If
the power supply cord is too short, have a qualified electrician
or serviceman install an outlet near the appliance.
5" (127 mm)
4"
(101.6 mm)
3-Prong plug
Grounding pin
3-Prong receptacle
Grounded receptacle box
SHARP ELECTRONICS OF CANADA LTD
335 Britannia Road East • Mississauga, Ontario • L4Z 1W9
dRAWER INStALLAtIoN
Anti-Tip block
6"
(152.4 mm)
3 1/2"
(89 mm)
Figure 8A
1. Place the drawer adjacent to the wall or
cabinet opening. Plug the power supply cord
into the electrical outlet.
2. Carefully guide the drawer into the prepared
opening. Avoid pinching the cord between
the oven and the wall.
3. Slide the drawer all the way until the
mounting flange is flush with the face of the cabinet. See
Figure 8A.
4. Open the drawer. Using the 4 holes on the drawer as a template,
pre drill the cabinet using a 1/16" bit. See Figure 8A.
5. Secure the drawer with the 4 screws supplied. See Figure 8B.
modEL ANd SERIAL NUmBER LoCAtIoN
The name plate includes model and serial number. Open the
Microwave Drawer fully. The label is beyond the back wall of
the microwave cavity facing up from the flat surface.
CARE, CLEANING ANd mAINtENANCE
Refer to the Operation Manual for cleaning instructions.
Grounded receptacle box
Grounding adapter
BEfoRE yoU CALL foR SERvICE
Read the BEFORE YOU CALL and operating instruction sections
Screw
in your Operation Manual. It may save you time and expense.
Tab for grounding screw
The list includes common occurrences that are not the result of
defective workmanship or materials in this appliance.
Refer to the warranty in your Operation Manual for Sharp's
service number and address. Please call or write if you have
inquiries about your microwave product and/or need to order
parts.
E 4
Mounting
flange
Parts supplied
4 Screws
Figure 8B
Advertisement
