Advertisement
CLEARANCES ANd dImENSIoNS
• Dimensions that are shown in Figure 1 (for 24") or Figures
3 and 4 (for 30") must be used. Given dimensions provide
minimum clearance. Locate electrical outlet in the shaded
area in the upper left-hand corner of the cutout. See Figure 7.
• Contact surface must be solid and level. Pay special attention
to the floor on which the Microwave Drawer will sit. The
floor of the opening should be constructed of plywood
strong enough to support the weight of the oven (about 100
pounds).
24" mICRoWAvE dRAWER mEASUREmENtS
B
F
G
I
J
L
P
Figure 1
A. 6" (152.40 mm)
B. Suggested electrical outlet location*
C. Anti-Tip block
D. 5" (127 mm)
E. 3-1/2" (88.90 mm)
F. 4" (101.60 mm)
G. 22-1/8" (561.98 mm) opening
H. 14-13/16" (376.24 mm) to bottom of Anti-Tip block
I. Allow 7/8" (22.23 mm) overlap
J. 23-1/2" (596.90 mm) minimum depth
K. Allow 3/16" (4.76 mm) overlap
L. 36" (914.4 mm) countertop height
M. Allow 7/16" (11.11 mm) overlap
N. Floor must support 100 lb (45.4 kg)
O. 19" (482.60 mm) to top of floor
P. 24" (609.6 mm) cabinet minimum
Q. 14-13/16" (376.24 mm) opening
A
D
H
K
Q
I
M
O
• Check location where the Microwave Drawer will be
installed for proper electrical supply.
• Your oven can be built into a cabinet or wall by itself or
under a gas or electric wall oven.
• Be sur
e that the clearance of the floor between the wall oven
and the microwave drawer is a minimum of 2-inches.
• The microwave interior will easily accommodate a 9" x 13"
oblong dish or a bag of microwave popcorn.
C
E
F
N
Figure 2
A. 21-5/8" (549.28 mm)
B. 4-11/16" (119.06 mm)
C. 1-3/4" (44.45 mm)
D. 21-7/8" (555.60 mm)
E. 23-7/8" (606.43 mm)
F. 15" (381 mm)
Figures 1 and 2 contain many Microwave Drawer measurements
for reference when planning the drawer's location.
This Microwave Drawer can be installed below any electric or
gas wall oven.
* Can also be installed using an electrical outlet in an adjacent cabinet
within the area where the provided electrical cord can reach. Power
cord access hole in cabinet should be a minimum 1
hole and deburred of all sharp edges.
IMPORTANT
electrical outlet to prevent tension.
Always check electrical codes for requirements.
E 2
B
C
J
E
G. 14-19/32" (370.69 mm)
H. 1-11/16" (42.86 mm) door thickness
I. 15" (381 mm) auto drawer opening
J. 4" (101.6 mm)
Always allow sufficient power cord length to the
A
G
I
D
H
/
" diameter
1
2
Advertisement
