Table of Contents
Advertisement
20
Barracuda ATA II 100 Family Product Manual, Rev. A
•
The screws should be inserted no more than 0.200 inch (5.08 mm) into
the bottom mounting holes and no more than 0.14 inch (3.55 mm) into
the side mounting holes.
•
Do not overtighten the mounting screws (maximum torque: 6 inch-lb).
•
Do not use a drive interface cable that is more than 18 inches long.
Note. Dimensions are shown in mm (inches)
5.83 ± 0.38
[0.230 ± 0.015]
27.90 ± 0.27
[1.098 ± 0.011]
41.60 ± 0.33
[1.638 ± 0.013]
147.00 Max
[5.787]
[4.000 ± 0.013]
3X 6-32 UNC 2B
Max Insertion Depth
3X 6.35 ± 0.31
0.20 (5.0 mm) Both Sides
[0.250 ± 0.012]
Both Sides
9.28 (0.365)
Recommended
case temperature
measurement location
Figure 3. Mounting dimensions—top, side and end view
94.3± 0.8
[3.71± 0.03]
71.8 ± 0.8
[2.83 ± 0.03]
56.5 ± 0.8
[2.23 ± 0.03]
Pin One J2
Pin One J3
Pin One J4
3.18 ± 0.27
[0.125 ± 0.011]
40.77 ± 0.27
[1.605 ± 0.011]
44.45 ± 0.33
[1.750 ± 0.013]
101.60 ± 0.33
4X 6-32 UNC 2B
Max Insertion
Depth 0.22 (5.6 mm)
50.3 (2.00)
26.10 Max
[1.028]
4.66± 0.38
[0.183 ± 0.015]
95.24 ± 0.35
[3.750 ± 0.014]
101.85 Max
[4.010 Max]
Recommended
case temperature
measurement location
Advertisement
Table of Contents
