Section 1 - General Information; Introduction; Directional Reference; Servicing The Engine And Drive Train Components - Scag Power Equipment STC Operator's Manual

Section 1

1.1 INTRODUCTION

Your mower was built to the highest standards in the
industry. However, the prolonged life and maximum
efficiency of your mower depends on you following the
operating, maintenance and adjustment instructions in this
manual.
If additional information or service is needed, contact your
Scag Power Equipment Dealer.
We encourage you to contact your dealer for repairs. All
Scag dealers are informed of the latest methods to service
this equipment and provide prompt and efficient service in
the field or at their service shop. They carry a full line of
Scag service parts.
USE OF OTHER THAN ORIGINAL SCAG
REPLACEMENT PARTS WILL VOID THE
WARRANTY.
When ordering parts, always give the model and serial
number of your tractor. The serial number plate is located
where shown in Figure 1-1.
SERIAL NUMBER
PLATE LOCATION
Model
Serial
Figure 1-1 Tractor Serial Number Plate Location
GENERAL INFORMATION
SCAG
Power Equipment
STC 2001 SPL-1
For pictorial clarity, some illustrations and figures in this
manual may show shields, guards or plates open or removed.
Under no circumstances should your mower be operated
without these devices in place.
All information is based upon product information
available at the time of approval for printing. Scag
Power Equipment reserves the right to make changes
at any time without notice and without incurring any
obligation.
1.2 DIRECTION REFERENCE
The "Right" and "Left", "Front" and "Rear" of the machine
are referenced from the operator's right and left when
seated in the normal operating position and facing the
forward travel direction.
1.3 SERVICING THE ENGINE AND DRIVE
TRAIN COMPONENTS
The detail servicing and repair of the engine, hydraulic pumps
and gearboxes are not covered in this manual; only routine
maintenance and general service instructions are provided.
For service of these components during the limited warranty
period, it is important to contact your Scag dealer or find a
local authorized servicing agent of the component
manufacturer. Any unauthorized work done on these
components during the warranty period may void your
warranty.
1