SATO CL408e User Manual
Internal rewinder
Hide thumbs
Also See for CL408e:
- Service manual (219 pages) ,
- Rfid manual (51 pages) ,
- Parts list (30 pages)
Related Manuals for SATO CL408e
Summary of Contents for SATO CL408e
-
Page 1: Internal Rewinder
Industrial Bar Code Printers SATO CL408e Internal Rewinder User’s Manual P/N W00405301 SATO America, Inc. 545 Weddell Drive Proc 72 Sunnyvale, CA 94089... - Page 2 Label Rewinder Kit REWIND SHAFT UNIT GUIDE FRAME UNIT SUB FRAME SCREW ASSORTMENT UNIT (4) BLADE SPRING SPRING ADJUST PLATE UNIT TIMING BELT CABLE STAY Steps Before Installation STEP PROCEDURE Fig. 1 SATO CL-408e Internal Rewinder...
- Page 3 Steps Before Installation RAISE THE TOP ACCESS DOOR AND REMOVE (2) SCREWS HOLDING THE SIDE COVER TO THE INSIDE FRAME Figs. 2 ELECTRONICS REMOVE SIDE COMPARTMENT COVER REMOVE (2) SCREWS HOLDING THE SIDE COVER TO THE OUTSIDE FRAME SATO CL-408e Internal Rewinder...
- Page 4 Internal Rewinder Installation STEP PROCEDURE TEAR BAR ROUTE CABLE THROUGH HOLE IN SIDE WALL ATTACH GUIDE FRAME REMOVE SCREW AND UNIT WITH SCREWS RETAIN FOR THE IN THREE PLACES GUIDE FRAME UNIT Figs. 3 SATO CL-408e Internal Rewinder...
- Page 5 OF THE BRACKET ON THE REWIND SHAFT IN THE ELECTRONICS SIDE Fig. 4 ACCESS PLATE REMOVE AND RETAIN (4) SCREWS ATTACH THE REWIND SHAFT UNIT WITH (4) PREVIOUSLY REMOVED SCREWS Fig. 5 ELECTRONICS SIDE Fig. 6 SATO CL-408e Internal Rewinder...
- Page 6 ROUTE THE BELT AROUND IDLER UNIT GEARS ON SUB FRAME UNIT AS SHOWN. PLACE THE SUB FRAME UNIT ON THE REWIND SHAFT UNIT BRACKET. THERE ARE (2) LOCATING PINS ON THE BRACKET. SECURE WITH SCREW Figs. 8 BELT ROUTING SATO CL-408e Internal Rewinder...
- Page 7 TO THE SURFACE OF SUB ADJUSTMENT SCREW - FRAME UNIT WITH (2) FOR ADJUSTING BELT SCREWS AS SHOWN. TENSION ATTACH SPRING BE SURE THE BELT IS ENGAGED ON THE GEAR OF THE ADJUST PLATE UNIT Fig. 10 SATO CL-408e Internal Rewinder...
-
Page 8: Roll Holder
Internal Rewinder Installation STEP PROCEDURE ATTACH CABLE STAY TO FRAME. ROUTE CABLE FROM GUIDE FRAME UNIT TO PC BOARD AT CN10 CONNECTOR Figs. 11 ATTACH (4) BLADE SPRINGS WITH SCREWS PROVIDED Figs. 12 ROLL HOLDER SATO CL-408e Internal Rewinder... - Page 9 THE SPINDLE AND SECURE WITH THE RETAINER. TURN THE SPINDLE CLOCKWISE TO TAKE UP SLACK PLACE ROLL HOLDER ON SPINDLE Figs. 14 SHUT OFF SWITCH - IS ACTIVATED WHEN THE REWIND SPOOL IS FULL OF LABELS SATO CL-408e Internal Rewinder...