Specifications; Troubleshooting - Zoom FIRE-30 Operation Manual

Power Output
Speaker
Inputs
Output
Drive
Effect Programs
Effect Modules
Program Patches
Sampling Frequency
A/D Conversion
D/A Conversion
Control Connector
Display
Dimension
Weight
Included Items
*0 dBm = 0.775 Vrms
*Design and specifications subject to change without notice.
• Power does not come on.
• Is power cord correctly plugged into AC outlet?
• Is [POWER] switch set to ON?
• No sound, or low volume.
• Is the guitar correctly connected to the FIRE-30?
See page 9 for information on connections.
• Is something plugged into the [RECORDING/PHONES] jack?
If something is plugged into the [RECORDING/PHONES] jack, the speaker is automatically
cut off.
• Is the [LEVEL] knob or [MASTER] knob turned down?
Turn the knobs clockwise while playing your guitar.
• Sound is too distorted or breaks up.
• [GAIN]/[LEVEL] knobs may be turned up too high?
Turn the knobs counter-clockwise. Adjust the volume with the [MASTER] knob.
• The foot switch does not toggle modes.
• Is a ZOOM foot switch connected?
Use only the foot switch ZOOM FS-01.
ZOOM FIRE-30
Specifications
36 W RMS
25 cm, 5 ohms
Guitar input : standard mono phone jack (nominal input level -20 dBm,input
impedance 470 kilohms)
AUX IN : standard stereo phone jack(nominal input level -20 dBm,input impedance
10 kilohms)
Combined recording/headphone output: standard stereo phone jack (nominal output
level +4 dBm with output load impedance 10 kilohms or higher)
22 types
19 types (10 MODULATION + 4 DELAY/REVERB + BOOST + SUSTAIN +
EDGE + BOTTOM + ZNR)
7 modules (MODULATION + DELAY/REVERB + BOOST + SUSTAIN + EDGE
+ BOTTOM + ZNR)
USER : 10 (rewritable, with store)
PRESET : 2 banks x 10 = 20
Total 30 patches
31.25 kHz
20-bit, 64-times oversampling
20-bit, 8-times oversampling
FOOT SW (FS01)
2-position 7-segment LED
485 mm (W) x 240 mm (D) x 410 mm (H)
12 kg
Power Cord

Troubleshooting

Troubleshooting
23