Rear Panel - Kustom GROOVE 1300 Owner's Manual

MODEL: GROOVE 1300™
BREAKER
RISK OF ELECTRIC SHOCK
DO NOT OPEN
ATTENTION
RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
SERIAL NUMBER
DESIGNED IN USA
MADE IN CHINA
Circuit Breaker:
This circuit breaker will trip when too much
current is applied to the amplifier. To reset: Turn
of switch, allow to cool for a few
POWER
minutes, then press circuit breaker button, and
turn the switch on. Note: If the Circuit
POWER
Breaker trips repeatedly when AC power is
applied, take the amplifier to an authorized
service center for repair.
Power Cord:
This supplies AC power to the amplifier. If the
cord becomes damaged, take the amplifier to an
authorized service center for repair.
Speaker Outputs:
Use
these jacks to connect the amplifier to
speaker cabinets using heavy duty Speakon
speaker cables. These jacks are connected
together internally. See
Ampli er Loading
(Page 8) for speaker cabinet loading
Chart
information. To prevent overheating and
Note:
possible loss of signal, do not connect a load
lower than 2 ohms. Be sure power is off before
making any speaker connections. To connect a
cable: Align tab on speaker cable connector slot.
Insert and twist one quarter turn clockwise to
lock. To remove a cable: Pull back release button
on cable connector, twist connecter counter
clockwise one quarter turn, and pull out
connecter.
Ground Lift Switch:
Activating this switch removes the ground
connection on the DIRECT OUTPUT jack.
this switch, if necessary to eliminate hum.

Rear Panel

CAUTION
CHASSIS SURFACE HOT
ATTENTION
SPEAKER OUTPUT
SUPERFICE DE CHASSIS CHAUDE
7
GROUND
LIFT
Direct Output Jack:
This is a line level output used to connect the amplifier
to another device, such as a mixer or recorder.
Pre EQ / Post EQ Switch:
When set to Pre EQ, the DIRECT OUTPUT signal
will be unaltered by the EQ sections of the preamp.
When set to Post EQ, the DIRECT OUTPUT signal
will reflect the entire sound (including EQ settings)
of the preamp. Note: The MASTER volume control
(front panel #15) and SOLO ON/OFF (front panel
#18) switch will have no effect on the DIRECT OUTPUT
signal.
Tuner Out Jack:
Use this jack to connect to a tuner or other line level
device. This jack is always active and is a pre-gain
output.
E ects Send Jack:
Use this jack to connect to the input of an external
effects processor. This jack can also be used as a
preamp out.
E ects Return Jack:
Use this jack to connect to the output of an external
effects processor. This jack can also be used as a
power amp in. The preamp output signal is
disconnected from the power amp when using this
jack.
Footswitch Jack:
This 3-conductor 1/4" jack is for connecting a
footswitch to the amplifier (Footswitch model KAC-
GFS 100 is included with the amplifier). The
footswitch will then control th Mute and Solo
features. Using this jack overrides the front panel
MUTE and SOLO switches.
25
TUNER OUT
PRE EQ
POST EQ
LINE LEVEL
DIRECT OUTPUT
EFFECTS LOOP
SEND RETURN FOOTSWITCH