Table of Contents
Advertisement
4.1 General Operation
1.
Press MODE repeatedly until < FM Radio > is showing up.
Or, press FM on remote control to enter FM mode.
For initial use, it will start at the beginning of the FM frequency range (87.50MHz).
Otherwise, the last listened FM station will be selected.
Note: or enter < Main menu >, and then turn
4.2 Scan Setting
By default, FM scans stop at any available station. This may result in a poor signal-to-noise
ratio (hiss) from weak stations.
To change the scan settings to stop only at stations with good signal strength, press MENU
< Scan setting > Strong stations only? Yes, press SELECT to confirm.
4.3 How to Scan
1.
To manually adjust frequency, while frequency shows up, press
0.05MHz per step, or
2. To auto-searching, while frequency shows up, simply press SELECT, or SCAN.
4.4 Audio Setting
By default, all stereo stations are reproduced in stereo. For weak stations, this may result in
a poor signal-to-noise ratio (hiss).
To play weak stations in mono, press MENU < Audio setting > Listen in mono only?
Yes, press SELECT to confirm.
Chapter 4 FM Mode
SELECT
to < FM >, press
21
SELECT
.
to confirm
or
to adjust it by
Advertisement
Table of Contents
