Cleaning And Care - Kalorik USK MW 26146 Operating Instructions Manual

Fax +32 2 359 95 50

BEFORE YOU CALL FOR SERVICE
If the oven fails to operate:
a) Check to ensure that the oven is plugged in securely. If it is not,
remove the plug from the outlet, wait 10 seconds and plug it in
again securely.
b) Check for a blown circuit fuse or a tripped main circuit breaker. If
these seem to be operating properly, test the outlet with another
appliance.
c) Check to ensure that the control panel is programmed correctly
and the timer is set.
d) Check to ensure that the door is securely closed. Otherwise, the
microwave energy will not flow into the oven.
e) Check to ensure that the steam generator is placed correctly
and that it is locked in place with the screw. Also check if it is
clean.
f) Check that the water tank and the waste water tank are placed
correctly and that they are clean.
IF NONE OF THE ABOVE RECTIFIES THE SITUATION, THEN CONTACT A
COMPETENT QUALIFIED ELECTRICIAN. DO NOT TRY TO ADJUST OR
REPAIR THE OVEN YOURSELF.

CLEANING AND CARE

1. Turn off the oven and remove the power plug from the wall
socket before cleaning.
2. It is very important to clean the oven door, as it is responsible for
the impenetrability of the oven. Therefore, make sure it is always
clean and make sure no object hinders the door from being
properly closed.
3. Keep the inside of the oven clean. When food splatters or spilled
liquids adhere to oven walls, wipe with a damp cloth. Mild
detergent may be used if the oven gets very dirty. Avoid the use
of spray and other harsh cleaners as they may stain, streak or dull
the door surface. The grill element has hinges; you can pull it
down to clean the roof of the oven cavity.
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International BELGIUM.
The pages must be reproduced and folded in order to obtain a
booklet A5 (+/- 148.5 mm width x 210 mm height). When folding,
make sure you keep the good numbering when you turn the pages
of the I/B. Don't change the page numbering. Keep the language
integrity.
36
Assembly page 36/82
USK MW 26146 - 080425