Attaching With The Holder - Roland GK-3 Owner's Manual

Attaching the GK-3 to the Guitar

■ Attaching with the Holder

1. Remove three screws from the
underside of the controller, then attach
the GK-3 to holder "A."
fig.1120e (Attaching to the Holder)
2. Loosen the guitar's end pin, and insert
holder "A."
fig.1130 (Attaching to the Guitar 1)
3. Screw in the end pin.
16
4. Attach holder "B" so that the guitar
fig.1140e (Attaching to the Guitar 2)
Holder A
5. Tighten holders "A" and "B" using the
GK-3
*
fig.1150 (Spacer LP)
body is sandwiched between the two
holders.
Holder B
flat washer, the spring washer, and the
cap nut.
When attaching the GK-3 to an arched top guitar,
place the cushion between the guitar and holder
"A."
Guitar Body
Cap Nut
Flat Washer
Spring Washer
GK-3
Cushion
Holder A
Cap Nut
Holder B