Universal Garage Door Opener (Homelink ® ) - Jeep grand cherokee User Manual

UNIVERSAL GARAGE DOOR OPENER (HomeLink
• Simultaneously, press and hold both the chosen HomeLink
transmitter button until the HomeLink
rapidly blinking light, then release both the HomeLink
buttons. This may take up to 30 seconds, or longer in rare cases.
• Press and hold the just-programmed HomeLink
constantly, programming is complete and the garage door should open.
NOTE:
• Only use this transceiver with a garage door opener that has a "stop and reverse"
feature as required by Federal safety standards. This includes most garage door opener
models manufactured after 1982. Do not use a garage door opener without these safety
features. Call toll-free 1–800–355–3515 or, on the Internet, at www.HomeLink.com for
safety information or assistance.
• If you are having difficulty programming your HomeLink
was manufactured after 1995, you may have a rolling code. Follow the steps below for
Programming A Rolling Code System.
Programming A Rolling Code System
• At the garage door opener motor (in the garage), locate the "learn" or
"programming" button. This can usually be found where the hanging antenna wire is
attached to the garage door opener motor (it is NOT the button normally used to open
and close the door).
• Firmly press and release the "learn" or "programming" button. The name and color of
the button may vary by manufacturer. Within 30 seconds, return to the vehicle and
press the programmed HomeLink
each time). If the device is plugged in and activates, programming is complete.
• If the device does not activate, press the button a third time (for two seconds) to
complete the programming.
ELECTRONICS
Programming HomeLink
Begin Programming
• The HomeLink
the overhead console.
• Erase all channels before you begin
programming by holding the two
outside buttons for up to 20 seconds
until the red indicator flashes.
• Park your vehicle outside of the garage
and turn the ignition switch to the
ON/RUN position.
• Place the hand-held transmitter 1 to 3 in
(3 to 8 cm) from the HomeLink
while keeping the indicator light in view.
indicator flash rate changes from a slow to a
®
button; if the indicator light stays on
®
button twice (holding the button for two seconds
®
buttons are located in
®
button and the hand-held
®
and the hand-held transmitter
®
and your garage door opener
®
)
®
®
buttons
®
53