Setting Up The Hip99 - iHome HiP99 Quick Start Manual

Hotel system for your iphone or ipod

Hide thumbs

Table Of Contents

Table of Contents

Battery Low Indicator

DST Indicator

Attach Rear Cover After Staff Adjusts These Control Settings and Functions:

Access to the power supply jack, time zone and clock and calendar settings and room volume is on the rear of the unit.

Attach the rear cover using the thumbscrew once these settings are complete to prevent tampering. Remove cover for any

future adjustments and reattach once adjustments are completed..

Connect HiP99 to Power Source

Plug the AC adaptor cable into the AC Adaptor Jack and the other end into a standard 120 VAC wall socket. Adaptor

must be plugged in to operate. The HiP99 does not operate on batteries.

Setting the Clock Time

This unit is a PRESET Clock/Radio; the clock is already preset at the factory. You just need to set the time zone for your

location.

1. Depending on your location and whether or not Daylight Saving Time (DST) is in effect, set the DST Switch located on

the back of the unit to +1 to add an hour or to -1 to subtract an hour or use the AUTO setting.

2. Set the DST Switch to AUTO to have the unit automatically adjust the time at the beginning and end of Daylight Saving

Time each year.

3. Press and hold the Time Zone Button located on the back of the unit. The Time Zone Indicator at the lower part of the

display flashes the current time zone. Turn the Set Wheel to select your time zone.

4. Press Time Zone Button again (or no button within 10 seconds) to exit the setting mode.

5. If the time showing is not correct, please see Setting Time and Calendar to set the clock.

Setting Time and Calendar

1. Press and hold the Clock Adjust Button located on the back of the unit until the time blinks on the display.

Turn the Set Wheel to adjust to correct time. Remember to set the correct AM or PM time.

2. Press the Clock Adjust Button again. The year will blink. Turn the Set Wheel until the current year is displayed.

3. Press the Clock Adjust Button again to adjust month and date. Turn the Set Wheel until the current month/date is

displayed.

4. Press the Clock Adjust Button again (or no button within 10 seconds) to exit the setting mode.

Room Volume

1. Slide the Volume Switch located on the back of the unit to High for large rooms or to Low for smaller rooms.

HiP99 display

Time Display

AM/PM Indicator

Radio Frequency / Alarm Time Display