Jonsered 2036 Workshop Manual page 40

4
40
Fuel system
Fix the carburettor gasket on the car-
burettor.
Place the filter holder against the car-
burettor and push in the screws so that
they stick out approx. 3 mm to simplify
centring to the spacing piece.
Tighten the screws and make sure not to
forget the earth cable.
Fit the air filter and handlebar, including
the pipe for the tank vent.
Dismantling mod. 2054/2055
Lift up the nonreturn valve.
Dismantle the carburettor screws.
Fit the carburettor gasket on the car-
burettor with gasket paste. Make sure
that it is turned the right way round so that
the impulse channel is not blocked.
Place the filter holder against the car-
burettor and fold in the screwdriver guide
over the adjusting screws.
Place the carburettor screws so that they
stick out approx. 3 mm and centre the
carburettor to the spacing piece.
NOTE!
Check that the choke lever goes into the
groove on the lever.
Tighten the screws for the carburettor
and the support over the the stop switch.
NOTE!
Do not forget the earth cable at the stop
switch.
Fit the air filter and handlebar, including
the pipe for the tank vent.
Dismantling mod. 2045/2055
Lift up the tank vent's nonreturn valve to
improve accessibility.
Place a screwdriver, or the like, to angle
up the carburettor so that it is easier to get
at the screws.
Unscrew the carburettor screws.