Recommended Original And Replacement Bar And Chain Combinations - Husqvarna 395XP Operator's Manual

Recommended original and replacement bar and chain combinations

These Husqvarna chain saw models are in the ANSI category of saws above 3,8 cu. in. and are not required to comply with low
kickback performance requirements. However, for these models we recommend the following cutting equipment.
Bar
Length, inch Pitch, inch
18-28 3/8"
18-28 3/8"
Listed ATM is the Oregon designation of Armour Tip Medium hard nose bar.
Note: For the chains above you are free to choose between 0,050", 0,058" and 0,063" gauge drive link for the corresponding bar,
see the table below.
0,050"/1,3 mm -
0,058"/1,5mm H42
0,063"/1,6 mm -
WARNING! This chain saw model is capable
!
of severe kickback that could result in
serious injuries to the user. Do not operate
this saw unless you have extraordinary
cutting needs and experience and
specialized training for dealing with
kickback. Saws with significantly reduced
kickback potential are available. Always use
the safest saw and cutting equipment
applicable to your cutting need.
TECHNICAL DATA
Max nose radius
11T Husqvarna H42, Oregon 73LP / 73LG / 73V
ATM 1,33" Husqvarna H42, Oregon 73LP / 73LG / 73V
72LP 72LG
73LP 73LG
73LP 73LG
Chain
72V
73V
73V
– 37
English