2.6X Installation; Installation - Rockford Fosgate 2.3 Installation And Operation Manual

2.3 & 2.6
High Level Input – "Single Ended" Type
This configuration is used for source units that have "Single Ended" speaker outputs.
Only the "+" output is "hot," whereas the "–" or "common" are common grounded. To
verify your source unit has these outputs, connect an ohm meter across the "–" output
and radio chassis for a reading of 0 .
®
Gain Input
L+R L
• L+ and R+ Inputs are connected to corresponding "+" speaker outputs
• L– and R– Inputs are not used
• GND Input is connected to "–" speaker outputs
High Level Input – "B.T.L." Type
This configuration is used for source units that have "B.T.L." speaker outputs (Bridged
Transformer Less not Bacon Tomato & Lettuce). Both "+" and "–" outputs are considered
"hot" or "floating."
®
Gain
L+R
• L+ and R+ Inputs are connected to corresponding "+" speaker outputs
• L– and R– Inputs are connected to corresponding "–" speaker outputs
• GND Input is not used unless noise problems arise
CAUTION: Use 1/8" female connectors when using the high level inputs and DO NOT
solder wires directly to the connector
I
X NSTALLATION
Factory Radio
+
–
Front
R+
GND
L+
®
High In
LED
L R
R
+ – + –
AUD
CLOCK
DISC Ch
DSPL
AMFM ST LD RDM RPT
VOL
PWR
D.SCN SCAN
1 2
® ®
Front
R–
R+
L–
L+
®
High In
Input
L R
L R
+ – + –
^ v
100.7
Speaker Speaker
B+
L + L -
R + R -
R
SEL
AUTO ILLUM
P.SCN LOUD
TUNE
RPT RDM DIM PAUSE
3 4 5 6
Speaker Speaker
LED
L + L -
R + R -
– 16 –
REM GND
B+ REM GND
I
® ®
N
S
T
A
L
L
A
T
I
O
N