Clock Operation; Mode Selection - Rockford Fosgate RFX9020 Installation & Operation Manual

• P. PLAY [EJ MUTE] — Plays the Tuner after you eject a CD while Eject Mute mutes the Tuner
after you eject a CD.
• V/BAR ON [V/BAR OFF] — Displays the Volume Bar at the bottom of the Front Panel while
Volume Bar Off turns it off.
• INI VOL 15 — Sets the maximum Initial Volume when the unit turns on. Initial Volume sets
point of maximum volume when the unit is turned on. If the volume setting was lower than the
initial volume setting when the unit is turned off, then the lower volume will be used at turn on.
If the volume setting was higher than the initial volume setting, then the initial volume setting is
used at turn on. This feature prevents accidental high volume turn on as well as allows high
volume settings to be retained in case another preamplifier is the system's main volume control.

CLOCK OPERATION

Setting the Clock Hours
1. Press and hold the DISP button for 1 second until the hour flashes.
2. Press DIR
Setting the Clock Minutes
1. Press and the DISP button a second time and the minutes will flash.
2. Press DIR
Your settings will be saved after the clock has flashed for 5 seconds.
NOTE: When the radio is off (sleep mode) the clock will be displayed.

MODE SELECTION

Press the MODE button repeatedly to cycle through the following
modes:
• CDP PLAY — Enables CD Player if a CD is inserted.
• FM1>FM2>AM — Enables the Tuner.
MUTE
1. Press the MUTE (7) button to dampen the volume.
2. Press the MUTE (7) button a second time to revert the audio to the
previous level.
NOTE: The panel will display MUTE until the function is canceled.
PUNCH
The Punch button enables the bass and treble response of the audio output to be
boosted for all listening levels.
1. Press the PUNCH (0) button to enable the Punch feature.
2. Press the PUNCH (0) button again to disable the Punch feature.
NOTE: The panel will display "Punch" when the Punch feature is on.
/ Button to set the hour.
/ Button to set the minutes.
O – B
PERATION ASIC
11