Related Manuals for Rockford Fosgate RFX9500DVD
Summary of Contents for Rockford Fosgate RFX9500DVD
- Page 1 RFX9500DVD Car Stereo DVD/SVCD/VCD/CD/MP3/MP4 Player with PLL AM/FM Stereo Radio iPod Compatible Front Aux Input Flip Down Front Panel...
-
Page 2: Before You Begin
BEFORE YOU BEGIN PRECAUTIONS: CAUTION: USE OF CONTROLS OR ADJUSTMENT OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. THE USE OF OPTICAL INSTRUMENTS WITH THIS PRODUCT WILL INCREASE EYE HAZARD. • Keep this manual handy as a reference for operating procedures and precautions. • Always keep the volume low enough so you can hear sounds outside of the car. • Protect this product from moisture. -
Page 3: Installation
INSTALLATION PRECAUTIONS • Choose the mounting location carefully so that the unit will not interfere with the normal driving functions of the driver. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration. • Use only the supplied mounting hardware for a safe and secure installation. • Be sure to remove the front panel before installing the unit. NOTE : Inclination angle for car radio installation must not exceed 30˚ otherwise the front panel will not open. Release screw and bracket 182mm 53mm Bend these claws, if necessay NOTE: Keep the release key in the safe place as you may need it in future to remove the unit from the car. TO SUPPORT THE UNIT Dashboard 1. UNIT 6. PLAIN WASHER . RELEASE CASE 7. CAR BODY . DASH BOARD 8. REAR SUPPORT STRAP 4. HEX NUT 9. TAPPING SCREW 5. LOCK WASHER 10. M5 X 15 HEX BOLT EN-... -
Page 4: Wire Connection
WIRE CONNECTION FRONT LINE OUT REAR LINE OUT SUBWOOFER (GREEN) Maintenance FUSE REPLACEMENT If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after the replacement, there may be an internal malfunction. In this case, consult your nearest repairing center. Warning Use the specified amperage fuse for each lead. - Page 5 (A/PS)
- Page 6 Locations of Parts (Remote Control) 1. POWER ON/OFF 2. MODE 3. PLAY/PAUSE 4. STOP/RETURN 5. SELECT MODE 6. SEEK+/SEEK- 7. VOL +/VOL- Title Sub-T 8. KEYPAD 9. GOTO Setup ENTER 10. AUDIO 11. ENTER Angle Slow 12. NAVIGATION VOL+/- 13. AUTO SEARCH / REPEAT VOL+ ZOOM PROG 14. RANDOM 15. BAND/SYSTEM SEEK–...
- Page 7 , IPOD mode. MODE Press DISP button to display clock.
-
Page 8: Listening To Radio
LISTENING TO RADIO Band button (BD) Each band is toggled cyclically by pressing this key FM1---FM2---FM3--AM1--AM2. Automatic or Manual tuning (FREQ UP OR FREQ DOWN When pressed short, these keys are operated as SEEK tuning mode. When pressed longer than 1 sec., they are operated as MANUAL tuning mode. Note: Unit automatically switch back to SEEK tuning mode after few seconds if no tuning was perform in MANUAL tuning mode. Auto seek/Preset scan (A/PS) Preset Scan (PS) - By pressing shortly, the radio plays each preset station for 5 seconds. -
Page 9: Playing Dvd Video
Searching for particular track using GOTO You can use the GOTO function to search for a desired track number or particular point of a track to play. 1. Press GOTO on the remote control. Track search appears. 2. Enter track number and press ENTER. Repeat tracks You can choose between repeat playback of a single track or all tracks. 1. Press RPT on the head unit or remote control during playback. 2. Every time you press this button, the unit switches to the following settings: • RPT 1 – Repeat the current playback track. • RPT DIR – Repeat the current playback directory. • RPT ALL – Repeat all tracks. • Off – Turn repeat off. Random Playback You can play the tracks in random/shuffle order instead of normal progression. Press RDM on the head unit or remote control during playback. To turn off, press it again. Intro Playback Press this button to play each track for 10 seconds. To turn off, press it again. Program Playback You can set which tracks to play according to your desired sequence using the PROG function. 1. Press PROG button on the remote control. - Page 10 Changing the subtitle language during playback (Multi-subtitle) With DVDs featuring multi-subtitle recordings, you can switch between subtitle languages during playback. Press Sub-T on the remote control during playback. Press repeatedly until the supported desired subtitle appears. Note: • With some DVDs, switching between subtitles may only be possible using a menu display. • You can also switch between subtitles using SET-UP MENU. Changing the viewing angle during playback (Multi-angle) With DVDs featuring multi-angle (scenes shot from multiple angles) recordings, you can switch among viewing angles during play-back.
- Page 11 2. Enter the track number and the chapter number besides the memory location. Up to 16 locations can be stored. 3. When all tracks have been programmed, select PLAY and press ENTER. Program playback will start. 4. Select CLEAR and press ENTER to clear program playback entries. PLAYING VCD/SVCD/MP4 Basic operation of Video CD 1. To perform fast forward or reverse, press and hold . To resume normal playback at a desired point, press 2. To skip back or forward to another chapter, press . Pressing skips to the start of the next chapter. Pressing skips to the previous chapter. 3. To pause playback, press . Press it again to resume. 4. To stop playback, press Turning PBC ON/OFF PBC (Playback Control) is a feature found on VCD 2.0 and SVCD 1.0. PBC allows control of the playback of play items and the possibility of interaction with the user through the remote control or some other input device available. If it’s on, the player won’t auto start after inserting the disc because it will take time to select program on disc; if it’s off, the player will auto playback the program on disc one by one. • To turn ON PBC function, press PBC on the remote control. To turn OFF, press the button again. Note: Not all VCD/SVCD disc have PBC functions.
-
Page 13: Setting Up The Dvd Player
SETTING UP THE DVD PLAYER Important 1. Load any disc into the unit before you can access the settings. 2. Press SETUP on the remote control. 3. Use the navigation key and press ENTER to setup the DVD player. Note: Depending on the type of disc inserted, some features may not be available. SETUP CATEGORY OPTIONS TV SYSTEM NTSC, PAL, AUTO AUTO PLAY ON/OFF TV TYPE 4:3 PS, 4:3 LB, 16:9 PASSWORD 1. Kid Safe SYSTEM SETUP 2. G 3. PG RATING 4. PG-13 5. PG-R 6. R 7. NC-17 8. Adult DEFAULT RESTORE OSD LANGUAGE AUDIO LANGUAGE SELECT PREFERRED AVAILABLE LANGUAGE SETUP SUBTITLE LANGUAGE OPTIONS APPEAR ON SCREEN MENU LANGUAGE... -
Page 14: Technical Specifications
TECHNICAL SPECIFICATIONS CD/MP3 PLAYER SECTION Signal to Noise Ratio > 60 dB Channel Separation > 50 dB (1kHz) Frequency Response 20 Hz - 20 kHz TUNER (FM) Frequency Range 87.5-107.9 MHz Channel Step 200 kHz Intermediate Frequency 10.7 MHz Sensitivity 2.8 µV Stereo Separation 30 dB Signal to Noise Ratio 50 dB TUNER (MW) Frequency Range 530-1710 KHz Intermediate Frequency 10.71 MHz Usable Sensitivity 32 dBmV LINE-OUT Output 5V max Impedance 10k Ohm GENERAL Power Supply 12V DC (10.8-15.6V allowable) Speaker Impedance 4 or 8 Ohm... -
Page 15: Troubleshooting
TROUBLESHOOTING Can not read some USB devices The unit is not 100% compatible with all USB devices or the USB device has special format. Try to format the USB device in FAT 16/32 standard. Can not play some iPod Your model unit is not compatible with new iPod Photo. Can not play the some songs download from website The songs may be in iTune DRM (digital right management) format or the format is not supported by the current unit. Unit takes about 60 seconds to recognize some USB device It is normal. The unit sometimes takes longer time to read all the files inside the USB device. LCD cant not display the MP3 song name correctly The songs are in foreign language or not in ID Tag 3 format.