Power Off; Power Off The Control Head; Power Off The Transducer Deployment System; Install The Pod Cover - Humminbird 360 Imaging Installation Manual

Power Off

The Transducer Deployment System is designed with software that keeps the pod
fully retracted and stowed while the boat is in use.
WARNING! To keep the pod retracted, the Transducer Deployment System
must stay powered ON while the boat is underway.
When the boat is stored or at dock, the Transducer Deployment System must
be turned off to prevent draining the battery. The pod cover must be installed
for trailering and storage.

1. Power off the Control Head

Press and hold the POWER/LIGHT key.
CAUTION Turning off the control head will NOT power off the Transducer Deployment
System.

2. Power off the Transducer Deployment System

Turn off power on the main switch, breaker, or battery switch.
NOTE: Powering off the Transducer Deployment System will be determined by the
installation and power connection on your boat.

3. Install the Pod Cover

The pod cover must be installed for trailering and storage.
Install the cover over the pod. Insert the T-clips into the tracks on each side
of the Transducer Deployment System. Turn each T-clip so it stays in the track.
Tighten the straps.
41 Power Off