Rqt Radio Programming - Ritron Quick Talk RQT-151-RCVR Owner's Manual

RQT Radio Programming

Programming an RQT transmitter (equipped with the
RQT-433-RCVR) for keyfob operation requires Ritron
PC Programmer RQT-PCPS or RQT-BASIC-PCPS
revision 1.1.0 or higher. A programmer update to this
revision is available at www.ritron.com/tech.
1. Connect the RQT radio to your computer via the
USB port and using the Ritron PC Programmer, read
out the radio programming. If the model indicated is
not on the following list, your radio is not equipped
with the RQT-433-RCVR keyfob receiver and cannot
be programmed for keyfob operation.
For assistance, call RITRON at 800-872-1872, or go to
Ritron Models with the RQT-433-RCVR installed:
RQT-151-RCVR
RQT-151M-RCVR
RQT-451-RCVR
2. Select the input you would like to program for
Keyfob operation. The input you select will depend
on the specific Ritron keyfobs you use. Check to
see which model keyfob you have and program the
input per the following list.
Input Models
Input 1 RQT-KEYFOB-1
Input 2 RQT-KEYFOB-3
Input 3 RQT-KEYFOB-5
Input 4 RQT-KEYFOB-7
3. From the left column of Input programming screen,
set the Input Type to Keyfob.
4. Press the Record button and record a unique
message for the Ritron keyfob indicated. Repeat the
process if a second keyfob is to be used.
5. Program the various attributes available on the Input
programming screen to customize how the RQT
transmitter will respond to the keyfob.
www.ritron.com
RQT-152-RCVR
RQT-152M-RCVR
RQT-452-RCVR
RQT-KEYFOB-2
RQT-KEYFOB-4
RQT-KEYFOB-6
RQT-KEYFOB-8
6