Advertisement
Acceleration
Turns pointer acceleration on/off and adjusts acceleration level. Note that acceleration is not recommended
for gaming.
5. USING YOUR RAZER DEATHADDER
SWITCHING DPI
You can switch between DPI in two ways:
a) By selecting the desired DPI in the Razer DeathAdder software driver.
b) By assigning the function to a button via the Razer Configurator in the main window.
MAKING MACROS
A macro is a short sequence of keystrokes. You can make a macro by following the instructions below.
1. Load the Razer Configurator.
2. Choose a mouse button and select Advanced Functions from its dropdown menu.
3. Click on the Macro button in the Advanced Functions panel.
4. Type in the desired sequence of keystrokes. You can also include delays by clicking on
"INSERT DELAY (50ms)"
5. Click APPLY when done.
SWITCHING PROFILES
You can switch between profiles in three ways:
a) By selecting the active profile in the Razer DeathAdder software driver.
b) By assigning the function to a button via the Razer Configurator in the main window
c) By using the Profile button located at the bottom of the mouse. Pressing the Profile button will advance
one Profile. [Required Razer Configurator to be installed]
When the active profile is switched, the Razer DeathAdder will flash the corresponding number of times –
For example, if Profile 3 is activated, the mouse will flash three times to indicate the profile you have
selected.
Advertisement
