Table of Contents
Advertisement
6.
Set the controls the same as for
normal starting (see pages
56 58
,
59 61
,
). Use the fast
idle control if needed.
Turn the ignition switch key to the
ON position.
55
KNOT
CUTOUT
7.
Set the alternator pulley so the
cutouts are on the right and left
sides of the alternator pulley as
shown. Hook the knot at the end of
the starter rope (accessory) against
a cutout in the alternator pulley,
and wind the starter rope one and a
half turns clockwise along the
groove in the alternator pulley.
EMERGENCY
Direction
STARTER
to pull
ROPE
ALTERNATOR
PULLEY
OPERATION
8.
Pull the emergency starter rope
slowly until resistance is felt, then
pull briskly.
Keep away from moving parts
while pulling the rope.
If necessary, rewind the rope and
pull again. If the engine does not
start after several attempts, refer to
TAKING CARE OF
UNEXPECTED PROBLEMS
116
118
.
Exposed moving parts can
cause injury.
Do not operate the
outboard motor without
the engine cover.
Use extreme care when
installing the engine
cover.
on p.
67
Advertisement
Table of Contents
