Starting A Cold Engine - Homelite CSP3314 Operator's Manual

STARTING A COLD ENGINE:

3. Move the chain brake to the BRAKE position.
NOTE: Set the chain brake by pushing the chain brake
lever/hand guard forward (towards the bar) to the brake
position. Refer to "Operation – Operating the Chain
Brake" later in this manual for additional information.
4. Set the ignition switch to the RUN (I) position.
5. Fully press and release the PRIMER BULB 7 times.
6. Pull CHOKE lever all the way OUT to full position.
7. Engage trigger release.
While squeezing both the trigger release and throttle
trigger, push in the throttle lock button. Release the
throttle trigger. This latches the trigger for starting.
CHOKE LEVER
FULL CHOKE
HALF CHOKE
RUN POSITION
OPERATION
THROTTLE
LOCK
BUTTON
Fig. 14
UK - Page 14
THROTTLE TRIGGER
STARTER
GRIP
TRIGGER
RELEASE
THROTTLE TRIGGER
RUN POSITION
TRIGGER
RELEASE
Fig. 15
Fig. 16
Fig. 17
Fig. 18