Chain Brake; Kick-Back Precautions - Homelite CSP3314 Operator's Manual

CHAIN BRAKE

Chain brakes are designed to quickly stop the chain from
rotating. When the chain brake lever/hand guard is pushed
towards the bar, the chain should stop immediately.
A chain brake does not prevent kick-back.
The chain brake should be cleaned and tested daily. Refer
to "Operation" later in this manual for additional information.
WARNING:
Even with daily cleaning of the mechanism, the
dependability of a chain brake to perform under field
conditions cannot be certified. Keep the SAFE-T-TIP
nose guard on the saw guide bar and use proper
cutting techniques.
OPERATION
RUN POSITION

KICK-BACK PRECAUTIONS

Rotational kick-back occurs when the moving chain contacts
an object at the Kick-back Danger Zone of the guide bar.
The result is a lightning-fast, reverse reaction which kicks
the guide bar up and back towards the operator.
This reaction can cause loss of control which may result
in serious injury.
BRAKE
POSITION
Fig. 5
UK - Page 11
WARNING:
KICK-BACK occurs when the moving chain contacts
an object at the upper portion of the tip of the guide
bar or when the wood closes in and pinches the saw
chain in the cut. Contact at the upper portion of the
tip of the guide bar may cause the chain to dig into
the object and stop the chain for an instant.
The result is a lightning-fast, reverse reaction which
kicks the guide bar up and back towards the operator.
If the saw chain is pinched along the top of the guide
bar, the guide bar can be driven rapidly back towards
the operator. Either of these reactions may cause
you to lose control of the saw, which could result in
serious injury.
Do not rely exclusively on the safety devices built
into the saw. As a chainsaw user, you should take
several steps to keep your cutting jobs free from
accident or injury.
KICK-BACK
DANGER ZONE
Fig. 6
ROTATIONAL
KICK-BACK
Fig. 7