Table of Contents
Advertisement
Popup Video – If it is checked, a pop up video window will appear on receiving an alarm
report.
Display Warning in the Electronic Map – If it is checked, the corresponding icon of that
channel in the electronic map will flash red on receiving an alarm report.
Write into Alarm Log – If it is checked, the alarm event will be written to the alarm log
4. Click Add to save the settings.
NOTE:
Available rules will be listed on the left side of the Event Configuration window.
GSurf allows you to have various alarm actions.
Edit alarm action rules
1. From GSurf, click Configuration > Event Configuration.
2. The Event Configuration window will pop up.
3. Select the rules you would like to edit.
4. Enter the required information.
5. Click Edit to save the changes.
Remove alarm action rules
1. From GSurf, click Configuration > Event Configuration
2. The Event Configuration window will pop up.
3. Select the rules you would like to remove.
4. Click Delete to remove the rule.
Configure the GSurf to take actions on alarm report
1. From GSurf, click Configuration > Device Configuration.
2. Select the device you would like to monitor the
alarm reports.
3. The configuration page will comes out.
4. In Alarm Triggers and Rules section, check
Triggers.
5. If you would like the monitor the Motion
Detection events, select a rule from the dropdown list. If you would like the monitor the
Alarm Input events, select a rule for it in the dropdown list. If you would like to monitor
both, select a rule for each of them.
NOTE:
The available rules you created in Event Configuration will be listed in the Select a
Rule dropdown list.
6. Click Save to save all the changes.
Firmware 1.0.0.17
Grandstream Networks, Inc. 08/2009
GSurf – Set up Alarm Triggers and Rules
Check Triggers and
select a rule
Page 12 of 18
Advertisement
Table of Contents
