Set Up Alarm Triggers And Rules - Grandstream Networks GSurf User Manual

3. Your web browser will open the web configuration pages of the device.
4. Click on Basic Settings > Video & Audio.
5. Configure the primary stream and secondary stream according to your preference.
Instructions for Alarm Triggers and Rules and Automatic Recording will be in the following
sections.

Set up Alarm Triggers and Rules

Grandstream's network cameras and digital video servers support motion detection and alarm events.
They can report motion detection or alarm events to GSurf.
GSurf can be configured to take actions – to notify such events to users. The instructions below will
assist you with this set up.
Configure the network cameras/digital video servers
Grandstream's network cameras and digital video servers need to be configured to report the motion
detection and alarm events to GSurf.
1. From GSurf Device Browser panel, right click on the device.
2. In the pop out menu, click Open the web configuration pages.
3. Your web browser will open the web configuration pages of the device.
4. Click on the Advanced Settings > Motion Detection/Alarm Events page.
5. In Alarm Actions Section, check Upload to Alarm Center.
6. Click Save to save the changes.
Add alarm action rules
A rule is described of what actions to take when certain
alarm triggers occurs.
1. From GSurf, click Configuration > Event
Configuration.
2. The Event Configuration window will pop up.
3. Enter required information
Rule Name – Enter a rule name.
Play Sound – If it is checked, GSurf will play a
sound when receiving an alarm report. Make sure
to select a sound file and the duration in which it
will be played.
Record – If it is checked, GSurf will record the video upon receiving an alarm report. Users
can also establish the duration of the recording.
Firmware 1.0.0.17
Grandstream Networks, Inc. 08/2009
GSurf – Set up Alarm Triggers and Rules
Available rules
Page 11 of 18