Abnormality; Alarm Output - Q-See QC40198 User Manual

MAIN MENU

5.5.2 Abnormality

Abnormality interface is shown in
Event type: There are several options such as disk error, no disk, disconnection, IP conflict etc.
Alarm output: Select alarm activation output port (multiple choices).
Latch: Here you set corresponding delaying time. The value ranges from 10s-300s. System automatically
delays the number of seconds you specify before turning off alarm and de-activating output after external alarm
ends.
Show message: system can display the message in the local screen to alert you when alarm occurs.
Alarm upload: System can upload the alarm signal to the network (including alarm center) if you enable this
function.
Send email: System can send out email to alert you when alarm occurs.

5.5.3 Alarm Output

Here is where you set proper alarm output.
Please highlight icon
After completing the setups please click OK button, system goes back to the previous menu. See Figure 5-31.
Figure 5-30.
X385H385H385H
to select the corresponding alarm output.
QC40198/QC40196 User Manual
Figure 5-30
Figure 5-31