Activate Auto Scan - Q-See QC40198 User Manual

NAVIGATION AND CONTROLS
QC40198/QC40196 User Manual
4.9.8

Activate Auto Scan

As shown in Figure 4-36, click "Auto Scan" button to begin system auto scan. During scan the auto scan button
becomes Stop button. Click stop button to terminate scan operation.
As shown in Figure 4-36, click the page switch button to get the interface illustrated in Figure 4-45. From here, you
can set the auxiliary function. The aux value is relative to the Aux button of the camera.
Figure 4-45
Please note the direction buttons are to control the speed dome menu. The button definition is defined by the speed
dome protocol. The button becomes grey and invalid if current protocol does not support this function. The up/down
button is to switch between the items and the left/right button is to modify the setup.