Precor 9.31 Owner's Manual page 15

Diagram 10 Secure the display
console and center
handrail.
Center handrail
mounting bracket
(right side)
¾-inch
with washers (D)
(right side)
Side bracket screw
(C) with washer (E)
(left side)
Diagram 11 Secure the the upper
handrail clamp.
Handrail clamp
Washer (E) with
1½-inch
Tighten the screws,
but leave room for
adjustments.
12. Install fasteners in the handrail clamp. Diagram 10. Return to the center
screws (C)
c. Align the handrail's mounting bracket with the holes in the upright support.
Insert two ¾-inch screws (C) with washers (D) and finger tighten. Do not
securely tighten the screws until both sides of the center handrail have been
attached. See Diagram 10, #1.
d. Align the handrail with the side bracket mount. Place a washer (E) on screw
(C) and insert the screw through the handrail and into the side bracket.
Finger tighten. See Diagram 10, #2.
e. Follow steps 9a. through 9d. on the opposite side.
screw (F)
handrail clamp and place a large washer (E) onto each of two screws (F). Thread
the screws through the handrail clamp. Finger tighten.
page 15