Precor P20 Console Operating & Maintenance Manual page 22

20
Event
Number
22
23
24
26
27
28
29
30
31
32
33
40
42
43
44
45
50
53
54
55
60
61
Hour Meter
Tracks the number of hours that a piece of equipment has
run. The equipment also tracks elapsed minutes, but the value
that displays is rounded up the nearest full hour.
Operating and Maintaining the P20 Console
Description of Event
No motor pulses at start up
Motor pulses missing after start up
Reduce speed requested, speed is not reducing
Motor pulse width incorrect
Too much drive motor current
Temperature too high
Excessive AC input current
Communications event lower board to upper board
Incorrect Communications event upper board to
lower board
Communication event upper board to lower board
Incorrect communications event lower board to
upper board
Lift motion detected
Lift position value out of range
Zero switch not found
Un-commanded lift motion
Lift going in the wrong direction
Too much brake (magnet) current
Cannot read target, cannot find home switch
Target pulses lost during operation
Brake home switch activated unexpectedly
Auto Stop sensor failure (treadmill)
Auto Stop not present (treadmill)