Installing Drivers And Software - Foxconn SiS964 User Manual

Installing Drivers and Software

Windows XP/2000 Operating System
The driver is located on the provided floppy disk. Insert the floppy disk into
the floppy disk drive and click Browse.
Most floppy disk drives are configured as [A:]. Choose the [A:] drive in your
browser and the Si3112r.inf file for the SiI 3112. Select the file and click
Open:
Verify that the directly listed in this window is A: and click OK.
Now, a window verifying that the new Driver for the board has been properly
installed. Click Finish.
It is always good to Restart the computer after an installation.When asked to
do so, Click Yes.
To install SATARaid GUI, use Windows InstallShield by performing the
following:
1. After computer restarts, insert cd in disk drive.
2. Double-click on Install SATARaid.exe.
3. Follow on-screen instructions to complete installation. Note: Do
NOT install in the Start Up folder. Choose the Default folder
(normally Accessories or Administrative Tools or something
similar).
Attention:
After driver installation, please install JAVA-SATARaid.exe Windows user-
interface utility. When complete, please install java runtime environment j2re-
1_4_2-windows-i586-iftw.exe. Please note that when installing the java
kernel, this requires an internet connection (ideally high-speed) to download
the run-time environment.
Install WinXP With Silicon 3112A RAID0:
function in the RAID Configuration Utility - Silicon
1. Setup RAID0
Image
.
2. Insert a WinXP installation CD.
3. Press the <F6> when the following picture appears:
Serial ATA RAID User's Guide
49