Kwvu Model Series; Gz And Ih Model Series; Range Hood Care - Whirlpool GZ7730XGS1 Installation Instructions And Use & Care Manual

A B
A. Light switch
B. Fan switch
C. Indicator light
D. Speed switch
Operating the Fan
1. Slide the shelf forward.
2. Move the fan switch to 1.
3. Move the speed switch to the desired setting.
The speed may be increased, decreased, or turned oft at
anytime during the vent hood operation. The indicator light
should be on when the fan is running.
4. Move the fan switch to 0 or close the glass shelf.
The fan will shut off when the shelf is about 2" (5.1 cm) from
the closed position. When the shelf is opened, the fan will
operate at the last settings.
Operating the Light
1. Open the shelf about 1" (2.5 cm).
2. Move the light switch to the 1 position.
The light will be on each time the shelf is opened. The light
can be used for a night light by opening the glass shelf about
1" (2.5 cm).
3. Move the light switch to the 0 position.
Another option for turning the vent hood light off is to close
the shelf.
RANGE HOOD CARE
KWVU Model Series
Exterior surfaces:
• Clean the vent hood with a mild detergent and soft cloth.
• Do not use abrasive cleansers or steel-wool pads
Metal Filters:
For the best results, clean the filters often. Pull the tabs
downward to remove flilters. Place filters in dishwasher or hot,
soapy water to clean.
1. Use a 15-watt fluorescent bulb with :30" (76.2 cm) unit and
18-watt bulb with 86" (91.4 cm) unit.
2. Remove the screws above the light cover and set them aside.
3. Pull the light cover forward slightly and then downward to
remove the cover.
4. Replace the light bulb.
5. Lift cover back into position.
6. Replace the screws.
A. Screws
GZ and IH Model Series
A
A. Screws
13