Whirlpool GZ7730XGS1 Installation Instructions And Use & Care Manual page 10

13. Place the vent hood on its back side on a protected surface.
a) Slide the screen forward.
b) Pull the tabs to remove the filters,
c) Remove the terminal box cover.
d} Close the screen.
e) Slide the mounting brackets to the top position.
A. Terminal box cover
NOTE: For some installations using the recirculating kit, it
may be easier to attach the vent system to the hood before
lifting the hood into its final position, Seal the connection with
clamps.
Lift the vent hood into its final position and feed the electrical
wire through the wiring opening in the range hood. The
mounting brackets should overlap the cabinet bottom or
wood filler strips. Center the range hood.
A
2.
3.
Check that the front panel is parallel with the cabinet front
when the screen is pushed in. Slide the screen forward.
Tighten the mounting bracket screws so that the vent hood is
secured to the cabinet.
....... i
........
A___ _ .....
A. Mounting bracket screw
B. Flat-blade screwdriver
Align the hood front panel with the cabinet. Slide the screen
forward. Locate the 2 screws on each side and turn them
counterclockwise to loosen the screws. Adjust the front of the
vent vertically, %" (9.5 mm) up or down, or horizontally,
3/4"(19 mm) front to back, until the front is flush with the
cabinet. Tighten the screws. If it is necessary to adjust the
given dimensions, lower and add or remove the filler strips or
redrill mounting holes.
I /_
B
A. Phillips screwdriver
B. Adjustment screws
A. Mounting bracket
B. Cabinet bottom
C. Optional wood filler strip
D. Vent hood
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Disconnect power.
2. Connect the white wire of the power supply cable to the white
wire in the hood with a twist-on connector.
10