Advertisement
Quick Links
Digital Slave Strobe Housing
Thank you for purchasing the Digital Slave Strobe Housing,
This housing is waterproof and can be operated up to depths of
60 metres (200 feet). Please read this instruction manual carefully
before using the housing and store this instruction manual carefully
for your future reference.
Compatible Slave Strobe: Digital Slave Strobe
Function Switches can be fully controlled except for Flash Trigger and
Override Switch (will be set to ' AUTO')
60 metres (200 feet)
Dimensions: (
)47x(
)97.5x(
D
W
(
)1.9x(
)3.8x(
D
W
200g(7.0oz)
10
Mode Switch
12
Dial Lock
Opening and Closing the Housing
Housing
Release the Security Lock.
Housing
Lock the Security Lock.
)104.5mm
H
)4.1inch
H
Light Output Control Knob
11
Security Lock
12
housing
as well as the O-ring for any deficiency such as cracking, scratches,
distortion, dirt and so on. Then, close the housing rear cover without loading
the Digital Slave Strobe. Immerse the housing into a water tank for one
minute at about 40cm (15 inches) depth, watching for bubbles or other
signs of leakage.
housing
housing
cover damage caused by the above, or when the user fails to conduct
the Water Leakage Test as instructed in this manual.
C) Open the housing according to above Opening and Closing the
Housing.
closed and close security lock.
G) Perform the Water Leakage test again as above Water Leakage Test.
Usage Tips
In very clear water and bright conditions, such as shallow depth and white
sandy bottom, strobe sensor may not "see" camera's flash, and will
not trigger Digital Slave Strobe. Try connecting a commercially
available fiber optic cable not included between the housing's diffuser
holder and camera housing.
To soften light, or reduce strobe light output, attach one of the included
diffusers to the diffuser holder.
housing,
housing
leakage
Warranties for this product do not
housing
rotate Dial Lock to fully
housing
Advertisement
