Whirlpool T2WG2 Use & Care Manual page 6

You cancontrol theamount ofhumidity inthemoisture-sealed
crisper. Adjust thecontrol toanysetting b etween LOW andHIGH.
LOW (open) forbest s torage offruits and vegetables withskins.
HIGH (closed) forbest s torage o ffresh, leafy vegetables.
Cool a irfrom thefreezer isdirected totherefrigerator door b in
directly b eneath thevents.
NOTE: The dairy compartment andcanrack are notassociated
with theChilled D oor B infeature.
Chilled Door Bin Control
The chilled door bin control is located on the left-hand side of the
refrigerator compartment.
A. Chilled door bin control
Turn the control clockwise (right) to reduce the flow of cold air
to the bin and make it less cold.
Turn the control counterclockwise (left) to increase the flow of
cold air to the bin and make it colder.
Cut Hazard
Use a sturdy glass when dispensing ice or water.
Failure to do so can result in cuts.
Depending on your model, your water and ice dispensers may
have one or more of the following features: a rotating water
dispenser faucet and pull-out tray, a special light that turns on
when you use the dispenser, or a lock option to avoid
unintentional dispensing.
NOTES:
• Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system.
If your model has a base grille filter system, make sure the
base grille filter is properly installed.
The dispensing system will not operate when the freezer door
is open.
After connecting the refrigerator to a water source, flush the
water system by dispensing water into a sturdy container until
you draw and discard 1.5 gal. (5.4 L) of water, or for
approximately 3 minutes after the water begins dispensing.
The flushing process cleans the water system and clears air
from the lines. As the air is cleared from the lines, water may
spurt out of the dispenser.
Allow several hours for the refrigerator to cool down and chill
water.
Allow 24 hours to produce the first batch of ice. Discard the
first three batches of ice produced.
The Water Dispenser
IMPORTANT: Dispense enough water every week to maintain a
fresh supply.
To Dispense Water (Standard):
1. Press a sturdy glass against the water dispenser pad OR
place the glass below the water dispenser and press the
WATER button.
NOTE: While dispensing water and for 5 seconds after
dispensing has stopped, the digital display will show how
much water has been dispensed. The default unit is ounces.
To switch to cups or liters, press the UNITS button before
dispensing.
2. Remove the glass OR release the button to stop dispensing.
To Dispense Water (Measured Fill):
Measured Fill allows you to dispense a specified amount of water
with the touch of a few buttons. In Custom mode, you can
dispense any amount within a specified range. In Water Bottle
mode, you can dispense pre-set amounts according to the size of
the container.
NOTE: The exact amount of water you select will be dispensed.
Be sure that the container is empty and can hold the entire
volume. If ice is in the container, you may need to adjust your
selection.
1. Press MEASURED FILL until the light turns on. Press
MEASURED FILL again to turn the feature oft.
NOTE: The dispenser will automatically turn off Measured Fill
after one minute of inactivity. When Measured Fill is turned off,
any changes you have made will be lost and all defaults will be
restored.
2. Press CONTAINER to change from Custom mode to
Water Bottle mode.
(i_) Ounces
(1_}Water _ottle (_ Cups
(!_ Custom (_) Liters
CONTAINER
UNITS