Table of Contents
Advertisement
To Replace:
1. Hold oven door by the handle and place the top of the door
under the cooktop overhang.
2. Use front of leg to apply pressure to slide hinges into the slots
as far as possible,
3. Use side of leg to apply pressure to the bottom of the door
front.
4. Lift door slightly. Apply pressure and push until the hinges
have gone in fully.
5. Fully open the door.
6. Tighten clips with a #2 square or Phillips screwdriver.
D, I tJ
,0,,:,
The storage drawer can be removed. Before removing, make sure
drawer is cool and empty.
To Remove:
1. Pull drawer straight out to the first stop,
2. Lift up the back of the drawer and pull out.
To Replace:
1. Fit the ends of the drawer rails into the guides in the cavity.
2. Slide the drawer closed.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of
an unnecessary service call.
Nothing will operate
•
Is the power supply cord unplugged?
Plug into a grounded
outlet.
•
Has a household fuse blown or has the circuit breaker
been tripped? Replace the fuse or reset the circuit.
Cooktop
will not operate
•
Is the control knob set correctly? Push in knob before
turning to a setting.
•
On ceramic glass models, is the "Cooktop
Lockout" set?
See "Cooktop Lockout" section.
Right front surface cooking area will not operate
•
Cannot boil on right front surface cooking area? Press the
ACCUSlMMER
TM
switch to OFR Turn right front control knob
to HI for a rapid boil.
•
ACCUSIMMER
will not simmer? Turn right front control
knob on between the ACCUSIMMER LO and 4 settings, while
pressing the ACCUSIMMER
switch on.
•
ACCUSlMMER
surface cooking
area does not get hot
enough? Turn right front control knob to 4 while pressing the
ACCUSlMMER
switch on.
Excessive heat around cookware on cooktop
Is the cookware
the proper size? Use cookware about the
same size as the surface cooking area, element or surface
burner. Cookware should not extend more than 1 in. (2.5 cm)
outside the cooking area.
Hot Surface Indicator Light Stays On
•
Does the Hot Surface
Indicator Light Stay on after control
knob(s) have been turned off? See "Cooktop Controls"
section.
Cooktop
cooking results not what expected
•
Is the proper cookware being used? See "Cookware"
section.
•
Is the control knob set to the proper heat level? See
"Cooktop Controls" section.
•
Is the appliance
level? Level the appliance. See the
Installation Instructions.
Oven will not operate
•
Is the electronic oven control set correctly? See
"Electronic Oven Control" section.
•
Has a delay start been set? See "Timed Cooking" section,
•
On some models, is the Control
Lock set? See "Control
Lock" section,
18
Advertisement
Table of Contents
