Electronicovencontrol; Display; Start; 5. Stop/Cancel - Whirlpool GR556LRKP1 Use & Care Manual

ELECTRONICOVENCONTROL
1 2 3 4
14
1. Sequence Programming
2. Electronic Oven Control Display
3. Oven Light
4. ACCUSIMMER
TM
Pad
13 12 11 10 9 8 7 6 5
5. Stop/Cancel 8. Timer Functions
6. Start 9. Hour/Minute Adjustment
7. Clock Set 10. Timed Cooking/Timed Cooling
Food Poisoning Hazard
1!. Auto Clean
12. Temperature Adjustment
13. Oven Functions
14. Cool Function
The STOP CANCEL pad stops any function except the Clock,
Timer and Control Lock.
Do not eat food in oven if "PF" shows on the
electronic oven control display.
Doing so can result in food poisoning or
sickness.
When "PF" shows on the electronic oven control display, a power
failure has occurred and food in the oven may not be properly
cooled or fully cooked.
In the case of a power failure, do not eat the food in the oven.
Press any pad and reset the Clock if needed.
When power is first supplied to the appliance, "PF" and the
current time will appear on the display. Press any pad to clear
"PF" from the display.
When the oven is not in use, the display shows the time of day.
When performing a timed cook function, the display will show
either hours and minutes, or minutes and seconds.
The START pad begins any oven function. If not pressed within 5
seconds after pressing a function pad, the "START?" indicator
light will flash as a reminder. On some models, "START?" will
appear on the display.
If not pressed within 5 minutes after pressing a function pad, the
oven display will return to the time of day mode and the
programmed function will be canceled.
This is a 12-hour clock that shows a.m. and p.m.
To Set:
Before setting, make sure the oven and Timer are off.
1. Press CLOCK SET.
2. Press the HR or MIN "up" or "down" arrow pads to set the
time of day, including a.m. or p.m.
3. Press CLOCK SET or START.
Tones are audible signals, indicating the following:
One tone
• Valid pad press
• Oven is preheated (long tone)
• Function has been entered
Three tones
• Invalid pad press
Four tones
• End-of-cycle
• Reminder, repeating each minute after the end-of-cycle tones
Reminder Tones: Reminder tones may be turned off. Press and
hold STOP TIME for 5 seconds. "rEP OFF" will appear in the
display. Repeat to turn reminder tones back on, and "rEP on" will
appear in the display.
All Tones: All of the above tones are preset on. All except the
end-of-cycle tones can be turned off.